JLG 1100SB Service Manual User Manual
Page 75
Advertising
SECTION 3 - CHASSIS & TURNTABLE
3121265
– JLG Lift –
3-33
flanged hub (31) until assembling of the unit is com-
plete.
SCREW THE NUT (22) ON PARTIALLY IN ORDER TO PREVENT
THE FLANGED HUB (31) FROM COMING OUT OF THE GEARBOX
HOUSING (23) DURING THE FOLLOWING STEPS.
10.
By using a hoist place the torque multiplier
(ATZ.09.016.0) on the ring nut (22).
11.
By using the mutiplier (ATZ.09.016.0), tighten the
ring nut (22), using a torque wrench with an input
multiplier torque of 71 ± 3 ft.lbs.(96,5 ± 4, 5 Nm)
corresponding to an output multiplier torque of 3688
± 184 ft.lbs. (5000 ± 250 Nm).
12.
Stake the ring nut (22) near 2 seats at 180° of the
flanged hub (31) on the right side.
NOTE: Stake Ø 4+5 mm (depth 1+1,5 mm).
Advertising