Assembly, Assembly -13, Rod seal installation -13 – JLG 1100SB Service Manual User Manual
Page 247: Poly-pak piston seal installation -13, Wiper seal installation -13
SECTION 5 - HYDRAULICS
3121265
– JLG Lift –
5-13
Assembly
NOTE: Prior to cylinder assembly, ensure that the proper
cylinder seal kit is used. See your JLG Parts Manual.
Apply a light film of hydraulic oil to all components
prior to assembly.
1.
A special tool is used to install a new rod seal into
the applicable cylinder head gland groove.
WHEN INSTALLING ‘POLY-PAK’ PISTON SEALS, ENSURE SEALS
ARE INSTALLED PROPERLY. REFER TO WIPER SEAL INSTALLA-
TION FOR CORRECT SEAL ORIENTATION. IMPROPER SEAL
INSTALLATION COULD RESULT IN CYLINDER LEAKAGE AND
IMPROPER CYLINDER OPERATION.
2.
Use a soft mallet to tap a new wiper seal into the
applicable cylinder head gland groove. Install a new
wear ring into the applicable cylinder head gland
groove.
Figure 5-13. Rod Seal Installation
Figure 5-14. Poly-Pak Piston Seal Installation
Figure 5-15. Wiper Seal Installation