JLG 1100SB Service Manual - Manual (Page 378)

SECTION 6 - JLG CONTROL SYSTEM
6-94 – JLG Lift – 3121265
4544 45 44 TOWER LIFT PVG VALVE - SPOOL CANNOT REACH NEU-
TRAL X - 1250AJP only.
4545 45 45 TOWER TELESCOPE PVG VALVE - SPOOL CANNOT
REACH NEUTRAL X - 1250AJP only.
660 66 0 <<< COMMUNICATION >>>
662 66 2 CANBUS FAILURE - PLATFORM MODULE Platform Module CAN
communication lost.
666 66 6 CANBUS FAILURE - ENGINE CONTROLLER Engine Control Module
CAN communication lost. - ECM equipped engine only.
667 66 7 CANBUS FAILURE - MAIN LIFT PVG Main Lift PVG CAN com-
munication lost. - 1250AJP only.
668 66 8 CANBUS FAILURE - TOWER LIFT PVG Tower Lift PVG CAN com-
munication lost. - 1250AJP only.
669 66 9 CANBUS FAILURE - TOWER TELESCOPE PVG Tower Telescope PVG
CAN communication lost. - 1250AJP only.
6610 66 10 CANBUS FAILURE - BLAM BLAM CAN communica-
tion lost. - BLAM equipped vehicles
only.
6611 66 11 CANBUS FAILURE - CHASSIS MODULE Engine Control Module
CAN communication lost. - ECM equipped engine only.
6612 66 12 CANBUS FAILURE - CYLINDER LOAD PIN Cylinder Load Pin CAN
communication lost. - Cylinder Load Pin equipped
engine only.
6613 66 13 CANBUS FAILURE - EXCESSIVE CANBUS ERRORS There has been > 500 Bus
Off errors or >500 Bus Pas-
sive Errors.
6614 66 14 CANBUS FAILURE - MAIN ANGLE SENSOR #1 Angle Sensor #1 CAN
communication lost. - 1250AJP only.
6615 66 15 CANBUS FAILURE - MAIN ANGLE SENSOR #2 Angle Sensor #2 CAN
communication lost. - 1250AJP only.
6622 66 22 CANBUS FAILURE - TCU MODULE Machine Setup/ Telemat-
ics=YES, No device heart-
beat for 30 sec
6623 66 23 CANBUS FAILURE - GATEWAY MODULE Machine Setup/ Telemat-
ics=YES, No device heart-
beat for 30 sec
6629 66 29 CANBUS FAILURE - TELEMATICS CANBUS LOADING
TOO HIGH X -Telematics only
680 68 0 <<< TELEMATICS >>>
681 68 1 REMOTE CONTRACT MANAGEMENT OVERRIDE - ALL
FUNCTIONS IN CREEP X -Telematics only
810 81 0 <<< TILT SENSOR >>>
813 81 3 CHASSIS TILT SENSOR NOT CALIBRATED The Chassis Tilt Sensor
has not been calibrated.
815 81 5 CHASSIS TILT SENSOR DISAGREEMENT X
820 82 0 <<< PLATFORM LOAD SENSE >>>
825 82 5 LSS HAS NOT BEEN CALIBRATED The Load Sensing System
Module has not been cali-
brated.
Table 6-6. Diagnostic Trouble Code Chart
DTC
Flash
Code
Sequence Fault Message Fault Description Check