JLG 1100SB Service Manual - Manual (Page 348)

SECTION 6 - JLG CONTROL SYSTEM
6-64 – JLG Lift – 3121265
3. Plug the analyzer into the connector inside the
Ground control box.
4. Pull out the Emergency Stop switch and start the
engine.
5. The analyzer screen should read:
6. Use the arrow button to reach ACCESS LEVEL 2. Hit
Enter.
7. Enter the Access Code, 33271.
8. Use the right Arrow key to reach CALIBRATIONS. Hit
Enter.
9. Use the arrow keys to reach the TILT SENSOR. The
screen should read:
10. Press ENTER.
11. When prompted, swing turntable 180° to opposite
end of chassis.
12. Press ENTER. The screen should read:
13. Upon completing swing calibration, swing turntable
180° back to the stowed position.
14. Hit ESC twice to go back to CALIBRATIONS.