Lenze DDS v2.3 - Manual (Page 154)

Drive PLC Developer Studio
Editors
7-32
l
DDS EN 2.3
Output selected
If selecting an output, the operator will be inserted behind this output.
•
The first input of the operator will be connected to the selected output.
•
The output of the new operator will be connected to the branch the selected output was
connected to.
Organization unit, function or function block selected
If selecting an organization unit, function or a function block, the new operator will replace the old
element.
•
As far as possible, the branches will be connected as before the replacement.
•
If the old element had more inputs than the new element, the branches that cannot be
connected will be deleted. The same applies to the outputs.
Jump or Return selected
If selecting a jump or a Return, the organization unit will be inserted in front of this jump or Return.
•
The first input of the operator will be connected to the branch to the left of the selected
element.
•
The operator output will be connected to the branch to the right of the selected element.
Last cursor position in network selected
•
If selecting the last cursor position of a network, the organization unit will be inserted behind
the last element.
•
The first input of the organization unit will be connected to the branch to the left of the
selected position.
7.5.3.5 Input
Icon: Menu: InsertWInput Keyboard: <Ctrl>+<U>
Use this command to insert an operator input.
The number of inputs is variable for many operators (e. g. ADD may have two or more inputs).
Such an operator can be extended by an input as long as the input in front of which the new input
is to be inserted - or the operator itself if a bottom-most input is to be added - is selected.
The inserted input is pre-assigned with ” ???” .
•
Click this text to change it to the required constant or variable. Alternatively, use the Help
Manager (<F2>) to do so.
Note!
This command is also available in the ladder diagram editor.
Show/Hide Bookmarks