Lenze DDS v2.3 - Manual (Page 66)

Drive PLC Developer Studio
Working area
5-6
l
DDS EN 2.3
5.3 Basic settings
5.3.1 DDS options
Use the menu command Project ➞ ➞ ➞ ➞Options in the main menu to configure the display of your main
window. There are other setting options for DDS customization.
Unless otherwise defined, the settings made here will be stored in the DDS ini file and restored on
next start.
5.3.1.1 Options
Icon: - Menu: ProjectWOptions... Keyboard: -
Use this command to open the dialog box Options.
The options are divided into several categories. Select the required category from the left-hand side
of the field
Category with a mouse click, or use the arrow keys to do so, and set the required options
on the right-hand side.
OptionsWLoad & save
If an option is active, a tick appears in front of the option. (
ü)
Creating a backup
If check box Create backup is activated, the DDS saves the old file to a backup file with the
extension ” .bak” on each save to allow for the version before the last save to be restored.
Autosave
If check box Autosave is activated, your project, while being edited, will be constantly saved to a
temporary file with an ” .asd” extension in accordance with the specified time interval (save interval).
This file will be deleted when the program completes normally.
Should the DDS terminate ” abnormally” for some reason (mains failure, for example), the file will not
be deleted and the system will display a message on project re-launch to advise that a backup file
has been created. It is now up to the user to decide which file to open (original or backup file).
Autosave interval (min)
Enter a time interval in minutes for temporary backup.
Show/Hide Bookmarks