Lenze DDS v2.3 - Manual (Page 35)

Drive PLC Developer Studio
Program example
3-13
l
DDS EN 2.3
48.Name the newly inserted steps/transitions as shown below:
49.Define the following actions for the two new actions and the new transition condition:
Step Actions Information
COUNT
Counter increased by 1.
OFF
Both traffic lights will be switched
off for 10 seconds, and the counter
will be reset to 0.
Transition Actions Information
LIGHTOFF
Transition checks whether COUNTER
is greater than a certain number (in
this example: 7).
Our example switches the traffic light to night mode after seven cycles, then off for 10 seconds
before the system switches to day mode and the process starts again.
Tip!
Select File
➞ ➞ ➞ ➞Save as to save the project under a new name.
•
Use the dialog box Save as, input field File name to enter a name and then close the dialog
box with Save.
Show/Hide Bookmarks