Lenze DDS v2.3 - Manual (Page 180)

Drive PLC Developer Studio
Editors
7-58
l
DDS EN 2.3
7.8.2.5 Parallel branch (right)
Icon: Menu: InsertWParallel branch (right) Keyboard: <Ctrl>+<L>
Use this command to insert a parallel branch as right-oriented branch to the block selected in the
SFC editor.
•
For this purpose, the selected block must start and end with a step. The new branch then
consists of a step.
•
To enable jumps to the created parallel branch it must have a jump label.
7.8.2.6 Parallel branch (left)
Icon: Menu: InsertWParallel branch (left) Keyboard: -
Use this command to insert a parallel branch as left-oriented branch to the block selected in the SFC
editor.
•
For this purpose, the selected block must start and end with a step. The new branch then
consists of a step.
•
To enable jumps to the created parallel branch it must have a jump label.
7.8.2.7 Jump
Icon: Menu: InsertWJump Keyboard: <Ctrl>+<U>
Use this command to insert a jump at the end of the branch of the block selected in the SFC editor.
•
For this purpose, the branch must be an alternative branch.
•
The jump label Step must be substituted with the name of the destination step.
7.8.2.8 Transition jump
Icon: Menu: InsertWTransition jump Keyboard: -
Use this command to insert a transition followed by a jump at the end of the branch selected in the
SFC editor.
•
For this purpose, the branch must be a parallel branch.
•
The jump label Step must be substituted with the name of the destination step.
7.8.2.9 Add entry action
Icon: - Menu: InsertWAdd entry action Keyboard: -
Use this command to add an entry action to a step.
•
An entry action is executed once-only immediately after the step has been activated.
•
The entry action can be implemented in any language.
•
A step with entry action is identified with an ” E” in the bottom left-hand corner.
Show/Hide Bookmarks