Rockwell Automation 1756-DHRIO_DHRIOXT ControlLogix Data Highway Plus-Remote I/O Communication Interface Module - Manual (Page 133)

Rockwell Automation Publication 1756-UM514C-EN-P - June 2014 133
Using the Studio 5000 Environment in Remote I /O and Block Transfer Applications Chapter 10
8. To create a Block Transfer Write message, change the message
configuration as shown below.
9. Set the communication path for the message instruction.
1. Choose the Message Type from the
pull-down list.
2. Specify the Source Element. You can:
• Choose an element from the pull-
down (that is browse to the tag)
or
• Use the New Tag button to create
the tag where data is written to on
the remote module.
3. Type the Number of Elements being
written.
If you create a Tag, you must:
1. Name the tag.
2. Make sure the Data Type is Integer
(INT).
1. Use the Browse button to select the
path.
2. Select the destination module for the
message instruction.
3. Click OK.