Create the routing table – Rockwell Automation 1756-DHRIO_DHRIOXT ControlLogix Data Highway Plus-Remote I/O Communication Interface Module User Manual
Page 49
Rockwell Automation Publication 1756-UM514C-EN-P - June 2014
49
Using Programming Software in DH+ Applications
Chapter 4
Create the Routing Table
To create a routing table for your application, follow these steps:
1.
Start RSLinx.
2.
Browse the network.
3.
Use the left-side navigation bar to see your DH+ application, as shown in
the following example.
4.
When the 1756-DHRIO Configuration pop-up appears, select the
DHRIO Routing Table tab.
You must use RSLinx software to build the routing table based on the
1756-DHRIO and 1756-DHRIOXT modules in the ControlLogix
chassis. Each link ID (that is chassis backplane, channels A and B of any
1756-DHRIO and 1756-DHRIOXT modules in the chassis) is initially
undefined.
1. Expand the configuration tree until
your application appears on the right
side of the dialog box.
2. Right-click the 1756-DHRIO or 1756-
DHRIOXT module’s icon to see the
menu.
3. Click Module Configuration.
DHRIO Routing Tab