Rockwell Automation 1756-DHRIO_DHRIOXT ControlLogix Data Highway Plus-Remote I/O Communication Interface Module - Manual (Page 40)

40 Rockwell Automation Publication 1756-UM514C-EN-P - June 2014
Chapter 3 Installing the Modules
Before You Begin Follow these procedures before installing the module.
1. Identify the module features, as shown.
2. Install and connect a ControlLogix chassis and power supply.
3. Set the network type switches for each channel.
ATTENTION: If this equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be impaired.
Network Type Switches
Backplane
Connector Alphanumeric Status Indicators
Wiring Label
Front View
Note Address Switches
Side View
Channel
and Module
8-pin Mini-DIN
Programming
Terminal
Channel A
Connector
Channel B
Connector
43232
Network Type Switches (behind cover)
This example shows Channel A set for DH+
and Channel B set for RIO.
This example shows Channel A node address at 10
and Channel B node address at 24.
Node Address Switches (behind cover)
43233
Power Supply
Chassis
43234