Rockwell Automation 1756-DHRIO_DHRIOXT ControlLogix Data Highway Plus-Remote I/O Communication Interface Module - Manual (Page 78)

78 Rockwell Automation Publication 1756-UM514C-EN-P - June 2014
Chapter 5 Messaging Between PLC-5 and SLC 5/04 Controllers
Configure the Module Switches
In this application, you must set switches on the 1756-DHRIO and
1756-DHRIOXT modules for DH+ and the switches on the 1756-CNB
module to Node address 22.
Configure a Routing Table for the 1756-DHRIO Module
Use RSLinx to configure a routing table for the modules. The following figure
shows the routing table for this example.
Configure Message Instructions
Use RSLogix 5 software to configure the remote PLC-5 controller message
instructions being sent to ControlLogix controller B. The following figure shows
a message instruction for this example.