Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 32)

4–2 Installing Your Hardware
Publication 2755-6.9
Refer to the following steps to install your system hardware properly.
1. Make sure your scanner system is planned out properly. Refer to
chapter 3 for information regarding planning your scanner
system.
2. Mount the reader (Catalog Nos. 2755-LS7-SA, 2755-LS7-SB,
2755-LS7-RA, 2755-LS7-RB, 2755-LS7-SBV, or
2755-LS7-RBV) to the mounting plate (Catalog No.
2755-LS7-N) or directly to your mounting surface.
The dimensions of the reader are shown on the next page. The
dimensions of the mounting plate are shown below.
The maximum distance from the reader to another device is 3 ft.
(0.91 m). Use # 6 screws with maximum penetration of 0.15 in.
(3.81 mm). If you are not using the mounting plate, go to step #4.
Reader
Mounting Plate
Note: The drawing below is not to scale.
2.39 in. (6.08 cm)
3.85 in. (9.77 cm)
4.35 in. (11.04 cm)
2.60 in. (6.62 cm)
2.58 in. (6.57 cm)
2.08 in. (5.30 cm)
1.26 in. (3.21 cm)
Installing the System
Hardware