Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 9)

Chapter
1
Publication 2755-6.9
Introduction to AtomScan
+
Bar
Code Readers
This chapter can help you to get started using the AtomScan + Bar
Code Readers. We base the procedures here on the assumption that
you have an understanding of bar code scanners and control
equipment.
Because it is an introduction, this chapter does not contain detailed
explanations about the procedures listed. It does, however, reference
other chapters in this book where you can get more information.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the
referenced chapters and other recommended documentation before
trying to apply the information.
This chapter tells you:
•
what tools and equipment you need
•
procedures for getting your scanner system up and running
Have the following tools and equipment ready:
•
screwdriver
•
drill
•
tape measure
•
personal computer with terminal program and an RS-232 cable
Required Tools and
Equipment