Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 71)

5–26 Configuring Your Reader
Publication 2755-6.9
Serial Configuration Commands
The table starting below lists the serial configuration commands.
Function Command Parameter Format
Communications
Protocol
Kf <Kfprotocol,address>
Preamble Kd <Kdstatus,ASCII characters>
Postamble Ke <Kestatus,ASCII characters>
LRC Kc <Kcstatus>
Response Timeout KA <KAtimeout setting>
Communications
Intercharacter Delay KB <KBnumber>
Host Port Ka <Kabaud,parity,stop bits,data bits>
Auxiliary Port Ky
<Kymode,baud rate,parity,stop bits,data
bits>
Communications
Status Request
KT <KT?>
Triggering Mode Kg <Kgmode,filter time>
End of Read Cycle Kh <Khmode,time>
Serial Trigger
Character
Ki <Kicharacter>
External Trigger Level Kj <Kjmode>
Good Decode Read Km <Kmnumber>
Operations
Match Code Type Kn
<Kntype,sequential matching,match start
position,match length,wild card
character,sequence on no
read,sequence on every mismatch>
New Master Pin Kz <Kzstatus>
Number of Labels KL
<KLnumber of labels,multilabel
separator>
Operations Status
Request
KV <KV?>
Narrow Margins Ko
<Konarrow margin status,symbology ID
status>
Code 39 Kp
<Kpstatus,check digit status,check digit
output status,large intercharacter
gap,fixed code length status,code
length>
Code Types
Codabar Kq
<Kqstatus,start & stop match status,start
& stop output status,large intercharacter
gap,fixed code length status,code
length,check digit type,check digit
output>
I 2 of 5 Kr
<Krstatus,check digit,check digit
output,length 1,length 2>
UPC/EAN Ks
<Ksstatus,EAN status,supplementals
status,separator status,separator cha.>
Code 128 Kt <Ktstatus,fixed length,length>
Code Types Status
Request
KW <KW?>
Table continued on the next page.