Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 40)

4–10 Installing Your Hardware
Publication 2755-6.9
5. Plug the power supply into the interface box.
Interface Box
To Power Port
Power Supply
6. Connect the power supply cable to the power supply and to the
power receptacle supplying 100-240V ac.
To Power Receptacle
To Power Supply
Grounding Pin
7. Turn on the interface box.
If you are using a configuration terminal, you can now perform the
configuration sequence. Refer to chapter 5 for the reader
configuration sequence information.
After performing the configuration sequence:
1. Turn off power to the reader.
2. Unplug the configuration terminal from the interface box.
3. Connect the interface box to the host device.
4. Turn on the interface box.
Interface Box
Power Switch