Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 43)

4–13 Installing Your Hardware
Publication 2755-6.9
5. Plug a power supply into each interface box.
Interface Box
To Power Port
Power Supply
6. Connect a power supply cable to each power supply and to the
power receptacle supplying 100-240V ac.
To Power Receptacle
To Power Supply
Grounding Pin
7. Turn on each interface box.
If you are using a configuration terminal, you can now perform the
configuration sequence for the master reader. Refer to chapter 5 for
the reader configuration sequence information.
After performing the configuration sequence on the master reader:
1. Turn off power to the master reader.
2. Unplug the configuration terminal from the master interface box.
3. Connect the master interface box to the host device.
4. Turn on the master interface box.
Interface Box
Power Switch
5. Turn off power to the slave reader.