Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 87)

6–2 Hardware Operation
Publication 2755-6.9
Function Command Action
<A> Software Reset (does not save for power-on)
<Ad> Software Reset/Restore Default
<An> Software Reset/Read NOVRAM
Program Management <D> Enter Configuration Mode Program Management
<Z> Software Reset/Save Parameters for Power-on
<Zd> Restore/Save Default Configuration for Power-on
<Zp> Save Scanner Type, SPS, and Gain for Power-on
<H> Enable Laser Scanning (Laser On)
<I> Disable Laser Scanning (Laser Off)
<KE> Motor On
Device Control
<KF> Motor Off
<L1> Relay-1 Pulse
<L2> Relay-2 Pulse
<P> Autodiscriminate All Codes
<Q> Enable Code 39 Only ➀
Code Types
<R> Enable Codabar Only ➀
<S> Enable I 2 of 5 Only ➀
<N> No Read Counter
<O> No Read Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
Counter
<V> Match Code/Good Read Counter
<W> Match Code/Good Read Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
<C> Enter Decode Rate Test
Test <Ce> Enter Extended Decode Rate Test Test
<J> Exit Decode Rate Test; Exit Extended Decode Rate Test
<#> Display Software Part Number
<!> Display Checksum of EPROM
<?> Show Scanner Status
Status
<?1>
Show Software Status (Send Status Byte, Part Number, and ROM
Checksum. Display NOVRAM Checksum at Power Up, then Display
Current NOVRAM Checksum)
<E> Enable Match Code Option ➀
<F> Disable Match Code Option ➀
<G> Store Next Label Scanned as Master Label
Master Label
<)XXXX)> Download Master Label Information
<)> Request Master Label Information
<))> Delete Master Label Information
➀
The command can also be set in the configuration menu or with a serial configuration command.