Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 45)

4–15 Installing Your Hardware
Publication 2755-6.9
Follow the steps below to connect your system hardware together
when not using an interface box.
1. Determine which pins on the reader cable connector are needed.
Refer to appendix B for a listing of the connector pins of the
reader cable.
2. Construct a mating cable that attaches to the reader cable on one
end and to the other devices on the other end, used in the
application. These devices include:
•
RS-232 host device
•
5 V, 500 mA power supply
•
package detect sensor
•
new master input
•
default configuration input
•
devices connected to the reader which uses the TTL relay
outputs
3. Plug the reader into the mating cable.
4. Plug the mating cable into the host device, power supply, and
other devices as required by the application.
Connecting System
Hardware Together When
Not Using an Interface Box