Dell PowerVault MD3260i - Manual (Page 208)

Parameter Description
patternFile File path and file name of the file that contains a data
pattern to use as test data. Enclose the path and file name
with quotation marks (" ").
Diagnose RAID Controller Module iSCSI Host Cable
Description
NOTE: This command valid only for the PowerVault MD3600i storage array.
This command runs diagnostic tests on the copper cables between the iSCSI Host interface cards and a RAID controller
module. You can run diagnostics on a selected port or all ports. The ports must be able to support the cable diagnostics.
If the ports do not support cable diagnostics an error is returned
Syntax
diagnose controller [(0 | 1)]
iscsiHostPort[(all | (0 | 1))]
testID=cableDiagnostics
Parameters
Parameter Description
controller Specifies the RAID controller module on which you want
to run the cable diagnostic test. Valid RAID controller
module identifier values are 0 and 1. The identifier value
is 0 for the RAID controller module on the top and 1 for
the RAID controller module on the bottom when viewed
from the rear of the enclosure. Enclose the RAID
controller module identifier in square brackets ([ ]). If a
RAID controller module is not specified, the MD storage
management software returns a syntax error.
iscsiHostPort Specifies the iSCSI host port on which you want to run the
diagnostic tests. You can either run the diagnostics on all
iSCSI host ports or run it on a specific iSCSI host. Valid
values for the specific iSCSI host port identifiers are 0 or
1. Enclose the iSCSI host port identifier in square brackets
([ ]).
testID Specifies the identifier for the diagnostic test you want to
run. For this diagnostic test, the value is
cableDiagnostics.
208