Dell PowerVault MD3260i - Manual (Page 281)

Parameter Description
repositoryFullLimit The percentage of repository virtual disk capacity at
which you receive a warning that the snapshot image
repository virtual disk is nearing full. Use integer values.
For example, a value of 70 means 70 percent. The default
value is 75.
Notes
The repository virtual disk name is automatically created by the MD storage management software and the firmware
when you create a new snapshot group. You cannot rename the repository virtual disk because renaming the repository
virtual disk will break the linkage with the snapshot images.
Set Remote Replication
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command defines the properties for a remote replication pair.
Syntax
set remoteReplication (localVirtualDisk
[virtualDiskName] |
localVirtualDisks [virtualDiskName1 ...
virtualDiskNameN])
role=(primary | secondary)
[force=(TRUE | FALSE)]
syncPriority=(highest | high | medium | low |
lowest)
autoResync=(enabled | disabled)
writeOrder=(preserved | notPreserved)
writeMode=(synchronous | asynchronous)
Parameters
Parameter Description
localVirtualDisk or localVirtualDisks The name of the primary virtual disk for which you want to
define properties. You can enter more than one primary
virtual disk name. Enclose the primary virtual disk name in
square brackets ([ ]). If the primary virtual disk name has
special characters, enclose the primary virtual disk name
in double quotation marks (“ ”).
role The setting for the virtual disk to act as the primary virtual
disk or the secondary virtual disk. To define the virtual disk
as the primary virtual disk, set this parameter to primary.
To define the virtual disk as the secondary virtual disk, set
281