Dell PowerVault MD3260i - Manual (Page 230)

Remove Physical Disks From SSD Cache
Description
This command decreases the capacity of the SSD cache by removing Solid State Disks (SSDs).
Syntax
set ssdCache [ssdCacheName]
removePhysicalDisks=(enclosureID1,drawerID1,slotID1 ...
enclosureIDn,drawerIDn,slotIDn)
Parameters
Parameter Description
ssdCache The alphanumeric identifier (including - and _) of the SSD
cache from which you want to remove SSDs. Enclose the
identifier in square brackets ([ ]). If the SSD cache name
contains special characters or consists only of numbers,
you also must enclose the identifier in double quotation
marks (" ") inside square brackets.
removePhysicalDisks The physical disks that you want to remove from the SSD
cache. For high-capacity expansion enclosures, specify
the enclosure ID value, the drawer ID value, and the slot
ID value for each SSD that you want to remove. For low-
capacity expansion enclosures, specify the enclosure ID
value and the slot ID value for each SSD that you want to
remove. Enclosure ID values are 0 to 99. Drawer ID
values are 0 to 4. Slot ID values are 0 to 31. Enclose the
enclosure ID values, the drawer ID values, and the slot ID
values in parentheses.
Notes
You cannot remove all of the SSDs from the SSD cache using this command; at least one SSD must remain in the SSD
cache. If you want to completely remove the SSD cache, use the delete ssdCache command instead.
Remove Remote Replication
Description
NOTE: This command valid only with Fibre Channel storage arrays.
This command removes the replication relationship between the primary virtual disk and the secondary virtual disk in a
remote replication pair.
230