Dell PowerVault MD3260i - Manual (Page 247)

Revive Disk Group
Description
This command forces the specified disk group and associated failed physical disks to the Optimal state. All physical
disks assigned to the disk group must be installed before you attempt to run this command.
CAUTION: Correct use of this command depends on the data configuration on all of the physical disks in the disk
group. Never attempt to revive a physical disk unless supervised by a Customer or Technical Support
representative.
Syntax
revive diskGroup [diskGroupNumber]
Parameter
Parameter Description
diskGroup Number of the disk group to be set to the optimal state.
You must put brackets ([ ]) around the disk group number.
Revive Disk Pool
Description
This command forces a disk pool and its associated physical disks to the Optimal state.
CAUTION: Correct use of this command depends on the data configuration on all of the physical disks in the disk
pool. Do not try to revive a disk pool unless you are supervised by your Technical Support representative.
Syntax
revive diskPool [diskPoolName]
Parameter
Parameter Description
diskPool The alphanumeric identifier (including - and _) of the disk
pool that you want to revive. Enclose the
diskPoolName in
square brackets ([ ]).
247