Dell PowerVault MD3260i - Manual (Page 277)

Syntax
set (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2, slotID2...
enclosureIDn,slotIDn])
operationalState=failed
Parameters
Parameter Description
physicalDisk or physicalDisks The enclosure and the slot where the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID values
are 0 to 31. Enclose the enclosure ID values and the slot
ID values in square brackets ([ ]).
Set RAID Controller Module
Description
This command defines the attributes for the RAID controller modules.
Syntax
set controller [(0 | 1)]
availability=(online | offline | serviceMode) |
ethernetPort [(1 | 2)]=ethernetPortOptions |
globalNVSRAMByte [nvsramOffset]=
(nvsramByteSetting |
nvsramBitSetting) |
hostNVSRAMByte [hostType, nvsramOffset]=
(nvsramByteSetting |
nvsramBitSetting) |
IPv4GatewayIP=ipAddress |
IPv6RouterAddress=ipv6Address |
iscsiHostPort [(1 | 2 | 3 | 4)]=
iscsiHostPortOptions |
rloginEnabled=(TRUE | FALSE) |
serviceAllowedIndicator=(on | off)
Parameters
Parameter Description
controller The RAID controller module for which you want to define
properties. Valid identifiers for the RAID controller module
are 0 or 1, where, 0 is the RAID controller module in slot 0,
and 1 is the RAID controller module in slot 1. Enclose the
identifier for the RAID controller module in square brackets
([ ]). If you do not specify a RAID controller module, the
277