Show raid controller module, Parameters, Description – Dell PowerVault MD3260i User Manual

Page 322: Syntax

Advertising
background image

Parameters

None.

NOTE: When all firmware downloads have successfully completed, this command returns a Successful status.
If any firmware downloads fail, this command shows the firmware download status of each targeted physical disk.
This command returns the status values shown in the following table.

Status

Definition

Successful

Downloads completed without errors.

Not Attempted

Downloads did not start.

Partial Download

Downloads are in progress.

Failed

Downloads completed with errors.

Show RAID Controller Module

Description

For each RAID controller module in a storage array, this command returns the following information:

Status (Online, Offline)

Current firmware and NVSRAM configuration

Pending firmware and NVSRAM configuration configurations (if any)

Board ID

Product ID

Product revision

Serial number

Date of manufacture

Date and time to which the RAID controller module is set

Associated virtual disks (including preferred owner)

Ethernet port

Physical disk interface

Syntax

show (allControllers | controller [(0 | 1)]) [summary]

Parameters

Parameter

Description

allControllers

Returns information about both RAID controller modules in

the storage array.

controller

Returns information about a specific RAID controller

module in the storage array. Valid RAID controller module

322

Advertising