Dell PowerVault MD3260i - Manual (Page 259)

Parameters
Parameter Description
raw This parameter defines that the statistics collected are all
statistics from the RAID controller module start
‑of‑day.
Enclose the parameter in square brackets ([ ]).
baseline This parameter defines that the statistics collected are all
statistics from the time the RAID controller modules were
reset to zero using the reset storageArray
iscsiStatsBaseline command. Enclose the
parameter in square brackets ([ ]).
file The name of the file to which you want to save the
performance statistics. Enclose the file name in double
quotation marks (" ").
NOTE: This command does not automatically append
a file extension to the new file. You must specify the
file extension when you enter the file name.
NOTE: If you have not reset the iSCSI baseline statistics since the RAID controller module start ‑of‑day, the time at
the start ‑of‑day is the default baseline time.
Save Storage Array Performance Statistics
Description
This command saves the performance statistics to a file. Before you use this command, issue the set session
performanceMonitorInterval and set session performanceMonitorIterations commands to
specify how often statistics are collected.
Syntax
save storageArray performanceStats file="filename"
Parameters
Parameter Description
file Specifies name of the file to which to save the
performance statistics. You must put quotation marks (" ")
around the file name.
259