Dell PowerVault MD3260i - Manual (Page 374)

Parameters
None.
Notes
The controller firmware returns a confirmation that the diagnostic test was cancelled.
In addition, you can start the database configuration diagnostic test through the storage management software GUI;
however, you cannot stop the database configuration diagnostic test through the storage management software GUI. If
you want to stop a running diagnostic test, you must use the stop storageArray configDbDiagnostic
command.
If you try to use the stop storageArray configDbDiagnostic command after validation of the storage array
configuration is complete, you do not receive any message that the validation has finished. This behavior is expected.
Stop Storage Array iSCSI Session
Description
This command forces the termination of an iSCSI session.
Syntax
stop storageArray iscsiSession [sessionNumber]
Parameters
Parameter Description
sessioNumber The identifier number of the iSCSI session. Enclose the
identifier number of the iSCSI session in square brackets
([ ]).
Stop Storage Array Physical Disk Firmware Download
Description
This command stops a firmware download to the physical disks in a storage array that was started with the download
storageArray physicalDiskFirmware command. This command does not stop a firmware download that is
already in progress to a physical disk; however, this command stops all firmware downloads to physical disks that are
waiting for the download.
Syntax
stop storageArray physicalDiskFirmwareDownload
374