Dell PowerVault MD3260i - Manual (Page 217)

Parameters
Parameter Description
virtualDisk, snapVirtualDisk, or
cgSnapVirtualDisk The name of the specific virtual disk for which you want to
turn on or off the SSD cache. Enclose the virtual disk
name in double quotation marks (" ") inside of square
brackets ([ ]).
ssdCacheEnabled To turn on SSD cache, set this parameter to TRUE. To turn
off SSD cache, set this parameter to FALSE.
Notes
You can turn the SSD cache on or off for only one virtual disk at a time.
When you turn off SSD cache for a virtual disk, the SSD cache for that virtual disk is purged.
Enable RAID Controller Module Data Transfer
Description
This command revives a RAID controller module that quiesces while running diagnostics.
Syntax
enable controller [(0 | 1)] dataTransfer
Parameter
Parameter Description
controller RAID controller module that you want to revive. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module on the
top and 1 for the RAID controller module on the bottom
when viewed from the rear of the enclosure. You must put
brackets ([ ]) around the RAID controller module identifier.
If you do not specify a RAID controller module, the storage
management software returns a syntax error.
Enable Storage Array Feature
Description
This command enables a premium feature using a feature key file.
217