Dell PowerVault MD3260i - Manual (Page 33)

Recurring Syntax Syntax Value
[physicalDiskType=physical disk-type]
[enclosureLossProtect=boolean]
WWID string-literal
For hostPort identifiers this is a 16-digit hex number
without any colon delimiters.
nvsram-offset hexadecimal-literal
host-type string-literal | integer-literal
nvsram-byte-setting nvsram-value
(0x hexadecimal | integer-literal)
nvsram-bit-setting nvsram-mask, nvsram-value
(0x hexadecimal, 0x hexadecimal | integer-literal)
ipv4-address (0–255).(0–255).(0–255).(0–255)
ipv6-address (0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-list autoconfigure-vols-attr-value-pair
{ autoconfigure-vols-attr-value-pair }
autoconfigure-vols-attr-value-pair physicalDiskType=physical disk-type|
raidLevel=raid-level |
diskGroupWidth=integer-literal |
diskGroupCount=integer-literal |
virtualDisksPerGroupCount=
integerliteral |
hotSpareCount= integer-literal |
segmentSize= segment-size-spec
NOTE: The physicalDiskType parameter is not
required if only one type of physical disk is in the
storage array. If you use the physicalDiskType
parameter, you must also use the hotSpareCount
and diskGroupWidth parameters. If you do not
use the physicalDiskType parameter, the
configuration defaults to SAS physical disks.
NOTE: The virtualDisksPerGroupCount
parameter is the number of equal capacity virtual
disks per disk group.
create-virtual-disk-copy-attr-value-list create-virtual-disk-copy-attr-value-pair
{
create-virtual-disk-copy-attr-value-pair }
create-virtual-disk-copy-attr-value-pair copyPriority=highest | high | medium | low | lowest |
targetReadOnlyEnabled=boolean
recover-raid-virtual-disk-attr-value-list recover-raid-virtual-disk-attr-value-pair
{
recover-raid-virtual-disk-attr-value-pair }
33