Dell PowerVault MD3260i - Manual (Page 280)

Use the show controller NVSRAM command to show the NVSRAM information. When the duplexMode option is
set to TRUE, the selected Ethernet port is set to full duplex. The default value is half duplex (the duplexMode
parameter is set to FALSE).
To make sure that the IPv4 settings or the IPv6 settings are applied, you must set these iscsiHostPort options:
• enableIPV4=TRUE
• enableIPV6=TRUE
The IPv6 address space is 128 bits. It is represented by eight 16-bit hexadecimal blocks separated by colons. The
maxFramePayload option is shared between IPv4 and IPv6. The payload portion of a standard Ethernet frame is set to
1500, and a jumbo Ethernet frame is set to 9000. When using jumbo frames, all of the devices that are in the network path
should be capable of handling the larger frame size.
The portSpeed option is expressed as megabits per second (Mb/s). The following values are the default values for the
iscsiHostOptions:
• The IPv6HopLimit option is 64.
• The IPv6NdReachableTime option is 30000 milliseconds.
• The IPv6NdRetransmitTime option is 1000 milliseconds.
• The IPv6NdTimeOut option is 30000 milliseconds.
• The tcpListeningPort parameter is 3260.
Values for the portSpeed option of the iscsiHostPort parameter are in megabits per second (Mb/s).
Set Read-Only Snapshot Virtual Disk To A Read/Write Virtual Disk
Description
This command changes a snapshot virtual disk that is a read-only virtual disk to a snapshot virtual disk that is read/write
virtual disk. You can also use this command to define the repository for the read/write virtual disk.
Syntax
set snapVirtualDisk ["snapImageVirtualDiskName"] convertReadOnlyToReadWrite
[repositoryVirtualDisk="repos_xxxx" | repositoryFullLimit=percentValue]
Parameters
Parameter Description
snapVirtual Disk The name of the snapshot virtual disk that you want to
change from read-only to read/write. Enclose the
snapshot virtual disk identifier in double quotation marks ("
") inside of square brackets ([ ]).
repositoryVirtualDisk The name of the repository virtual disk has the snapshot
image. All repository identifiers have this form:
repos_xxxx where xxxx represents a four digit
numerical value. Enclose the snapshot virtual disk name in
double quotation marks (" ").
280