Set host channel, Set host group, Description – Dell PowerVault MD3260i User Manual

Page 272: Syntax, Parameters

Advertising
background image

Host Group Parameter

Host Has Individual Virtual Disk-to-

LUN Mappings

Host Does Not Have Individual Virtual

Disk-to-LUN Mappings

defaultGroup

The command fails.

The host is removed from the present
host group and is placed under the
default group.

NOTE: When you use this command, you can specify one or more of the optional parameters. You do not, however,
need to use all of the parameters.

NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.

Set Host Channel

Description

This command defines the loop ID for the host channel.

Syntax

set hostChannel [hostChannelNumber]

preferredID=portID

Parameters

Parameter

Description

hostChannel

The identifier number of the host channel for which you
want to set the loop ID.
The host channel identifier number is constructed by

combining the controller number and the host channel

number. Enclose the host channel identifier number in

square brackets ([ ]). Separate the controller number from

the host channel number with a comma.
For example, the identifier number for host channel 2 on

controller 0 would be [0,2].

preferredID

The port identifier for the specified host port. Port ID
values are 0 to 127.

Set Host Group

Description

This command renames a host group.

272

Advertising