Set virtual disk mapping, Parameters, Description – Dell PowerVault MD3260i User Manual

Page 313: Syntax

Advertising
background image

Parameters

Parameter

Description

target

Specifies the name of the target virtual disk for which to
define properties. You must put brackets ([ ]) around the
target virtual disk name. If the target virtual disk name has
special characters, you must also put quotation marks (" ")
around the target virtual disk name.

source

Specifies the name of the source virtual disk for which to
define properties. You must put brackets ([ ]) around the
source virtual disk name. If the source virtual disk name
has special characters, you must also put quotation marks
(" ") around the source virtual disk name.

copyPriority

Specifies the priority that the virtual disk copy has relative
to host I/O activity. Valid entries are highest, high,
medium, low, or lowest.

targetReadOnlyEnabled

Specifies whether the target virtual disk is write enabled
or read only. To be able to write to the target virtual disk,
set to FALSE. To prevent writing to the target virtual disk,
set to TRUE.

copyType

Use this parameter to identify that a virtual disk copy has a
snapshot (legacy). If the virtual disk copy has a snapshot
(legacy), set this parameter to online. If the virtual disk
copy does not have a snapshot (legacy), set this
parameter to offline.

NOTE: When using this command, you can specify one or more of the parameters. You do not, however, need to
use all of the parameters.

Set Virtual Disk Mapping

Description

This command defines the logical unit number (LUN) mapping between a virtual disk a host or host group. This command
is applicable to virtual disks in either a disk group or disk pools.

NOTE: You cannot use this command for a snapshot virtual disk that is used in online virtual disk copy

Syntax

set (virtualDisk ["virtualDiskName"] | virtualDisk <wwID> | accessVirtualDisk)

logicalUnitNumber=LUN

(host="hostName" |

hostGroup=("hostGroupName" | defaultGroup)

313

Advertising