Dell PowerVault MD3260i - Manual (Page 360)

Parameters
Parameter Description
sourceLocation This parameter specifies the location of the database.
• disk indicates that data comes directly from the
database on the physical disk.
• onboard indicates that data comes from the
RPA memory location
The default location is disk.
diagnosticType The level of diagnostic testing that you want to run on the
database. You can run one of these levels of testing:
fileSystem This option checks the structural
integrity of the database.
mirror
• When the
sourceLocation
parameter is set to
disk, the peer RAID
controller module
initiates a block check.
• When the
sourceLocation
parameter is set to
cache, the peer RAID
controller module
initiates a record check.
contentCheck This option performs a deep
analysis of each record's
contents.
The default value is fileSystem.
controller The RAID controller module that has the database on
which you want to run the diagnostic tests. Valid RAID
controller module identifiers are 0 or 1, where 0 is the
RAID controller module in slot 0, and 1 is the RAID
controller module in slot 1. Enclose the RAID controller
module identifier in square brackets ([ ]).
Notes
This command runs a consistency check against a configuration database. All database records are checked. Error data
is written to a file in the data folder on disk automatically. You do not need to specify an output file.
360