Dell PowerVault MD3260i - Manual (Page 287)

Passwords are stored on each storage array in a management domain. If a password was not previously set, you do not
need a password. The password can be any combination of alphanumeric characters with a maximum of 30 characters.
(You can define a storage array password by using the set storageArray command.)
The polling interval and the number of iterations that you specify remain in effect until you end the session. After you end
the session, the polling interval and the number of iterations return to their default values.
Set Snapshot Group Attributes
Description
This command defines the properties for a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
[userLabel="snapGroupName" |
repositoryFullPolicy=(failBaseWrites | purgeSnapImages) |
repositoryFullLimit=percentValue |
autoDeleteLimit=numberOfSnapImages |
rollbackPriority=(lowest | low | medium | high | highest)
Parameters
Parameter Description
snapGroup The alphanumeric identifier (including - and _) of the
snapshot group for which you are setting properties.
Enclose the snapshot group name in double quotation
marks (" ") inside of square brackets ([ ]).
userLabel The new alphanumeric identifier (including - and _) that
you want to give to the snapshot group. Use this
parameter when you want to rename the snapshot group.
Enclose the new snapshot group name in double quotation
marks (" ").
repositoryFullPolicy How you want snapshot image processing to continue if
the repository virtual disks for the snapshot image group
are full. You can choose to fail writes to the base virtual
disk (failBaseWrites) or delete (purge) the snapshot
images (purgeSnapImages). The default action is
purgeSnapImages.
repositoryFullLimit The percentage of repository virtual disk capacity at
which you receive a warning that the snapshot image
repository virtual disk is nearing full. Use integer values.
For example, a value of 70 means 70 percent. The default
value is 75.
autoDeleteLimit The maximum number of snapshot images that you want
to automatically delete if you have selected to purge the
287