Dell PowerVault DP600 - Manual (Page 101)

Installing System Components
101
System Battery
Replacing the System Battery
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Enter the System Setup program and record the option settings on the
System Setup screens. See "Using the System Setup Program" on page 47.
2 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
3 Open the system. See "Opening the System" on page 67.
4 See Figure 6-2 for the location of the system battery and then, starting
with PCI slot 6, remove as many expansion cards as you need to create
enough room in the expansion bay to work with the system battery. See
"Removing an Expansion Card" on page 90.
5 Remove the system battery.
NOTICE:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
a Support the battery connector by pressing down firmly on the
positive side of the connector. See Figure 3-19.
b While supporting the battery connector, push the battery toward
the positive side of the connector and pry it up out of the securing
tabs at the negative side of the connector.
book.book Page 101 Monday, September 14, 2009 1:53 PM