Dell PowerVault DP600 - Manual (Page 43)

About Your System
43
Remote configuration
update attempt
failed
System unable to process
Remote Configuration
request. Retry Remote
Configuration.
ROM bad checksum =
address
Expansion card
improperly installed or
faulty. Reseat the expansion cards.
Ensure that all appropriate
cables are securely
connected to the expansion
cards. If the problem
persists, see
"Troubleshooting
Expansion Cards" on
page 168.
Sector not found
Seek error
Seek operation
failed
Faulty diskette or hard
drive. See "Troubleshooting a
Diskette Drive" on
page 160 or
"Troubleshooting a Hard
Drive" on page 164 for the
appropriate drive(s)
installed in your system.
Shutdown failure Shutdown test failure. See "Troubleshooting
System Memory" on
page 158.
The amount of system
memory has changed
Memory has been added
or removed or a memory
module may be faulty. If memory has been added
or removed, this message is
informative and can be
ignored. If memory has not
been added or removed,
check the SEL to
determine if single-bit or
multi-bit errors were
detected and replace the
faulty memory module. See
"Troubleshooting System
Memory" on page 158.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 43 Monday, September 14, 2009 1:53 PM