Dell PowerVault DP600 - Manual (Page 159)

Troubleshooting Your System
159
CAUTION:
The DIMMs are hot to the touch for some time after the system has
been powered down. Allow time for the DIMMs to cool before handling them.
Handle the DIMMs by the card edges and avoid touching the DIMM components.
8 Reseat the memory modules in their sockets. See "Installing Memory
Modules" on page 110.
9 Replace the memory cooling shroud.
NOTICE:
Never operate your system with the memory cooling shroud removed.
Overheating of the system can develop quickly resulting in a shutdown of the
system and the loss of data.
10 Close the system. See "Closing the System" on page 68.
11 Reconnect the system to its electrical outlet, and turn on the system and
attached peripherals.
12 Enter the System Setup program and check the system memory setting.
See "Using the System Setup Program" on page 47.
If the amount of memory installed does not match the system memory
setting, then perform the following steps:
a Turn off the system and attached peripherals, and disconnect the
system from its electrical outlet.
b Open the system. See "Opening the System" on page 67.
c Remove the memory cooling shroud. See "Removing the Cooling
Shroud" on page 103.
d Swap the memory module in socket 1 with another of the same
capacity. See "Installing Memory Modules" on page 110.
e Replace the memory cooling shroud.
NOTICE:
Never operate your system with the memory cooling shroud removed.
Overheating of the system can develop quickly resulting in a shutdown of the
system and the loss of data.
f Close the system. See "Closing the System" on page 68.
g Reconnect the system to its electrical outlet, and turn on the system
and attached peripherals.
h As the system boots, observe the monitor screen and the indicators on
the keyboard.
book.book Page 159 Monday, September 14, 2009 1:53 PM