Dell PowerVault DP600 User Manual
Page 134
134
Installing System Components
a
Remove the screw on the top back of the system that secures the
system top panel.
b
Slide the panel back until it clears the chassis hooks and lift up to
remove the panel.
5 Disconnect the display module cable from the control panel board. See
6 Remove the three screws that secure the control panel board to the
system chassis and remove the board. See Figure 3-32.
7 Disconnect the control panel cable from the back of the control panel.
See Figure 3-32.
NOTICE:
Do not pull on the cable to unseat the connector. Doing so can damage
the cable.
a
Squeeze the metal tabs on the ends of the cable connector.
b
Gently work the connector out of the socket.
8 Remove the display module:
a
Insert the end of a paper clip into the hole on the right side of the
display module and gently pry the label off.
b
Using a T10 Torx driver, remove the two screws that secure the
display module to the system chassis.
c
Remove the display module from the chassis cutout.
book.book Page 134 Monday, September 14, 2009 1:53 PM