Installing the 1x2 flex bay drive bracket – Dell PowerVault DP600 User Manual
Page 125
Installing System Components
125
Installing the 1x2 Flex Bay Drive Bracket
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Remove the front bezel, if attached. See "Removing the Bezel" on
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
3 Open the system. See "Opening the System" on page 67.
4 Remove the flex bay filler panel, if present.
5 Insert the 1x2 flex bay bracket three-quarters of the way into the flex
bay. See Figure 3-26.
The flex bay bracket is keyed for correct insertion into the flex bay.
6 Connect the SAS cables to the flex bay bracket backplane:
a
Connect the SAS cable from the SAS_B connector on the 1x8
backplane board to the SAS_B_OUT connector on the flex bay
backplane board. See Figure 6-3 for the location of the SAS_B
connector on the 1x8 backplane board.
b
Connect the SAS cable from the SAS RAID controller daughter
card to the SAS_B_IN connector on the flex bay backplane board.
7 Connect the power cable to the flex bay backplane board (see
Figure 3-26) and to the power connector on the 1x8 backplane board
(see Figure 6-3).
book.book Page 125 Monday, September 14, 2009 1:53 PM