Dell PowerVault DP600 - Manual (Page 119)

Installing System Components
119
9 If the heat sink has not separated from the processor, carefully rotate the
heat sink in a clockwise, then counterclockwise, direction until it releases
from the processor. Do not pry the heat sink off of the processor.
10 Lift the heat sink off of the processor and set the heat sink aside.
11 Pull the socket-release lever 90 degrees upward until the processor is
released from the socket. See Figure 3-25.
12 Rotate the processor shield upward and out of the way.
Figure 3-25. Installing and Removing a Processor
13 Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
NOTICE:
Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
14 Unpack the new processor.
1 socket-release lever 2 processor shield 3 socket key (2)
4 ZIF socket 5 processor
5
1
3
2
4
book.book Page 119 Monday, September 14, 2009 1:53 PM