Dell PowerVault DP600 User Manual
Page 128
128
Installing System Components
2 Push outward on the plastic guide rails and gently pull up on the card
edges until the card-edge connector clears the socket on the system board.
See Figure 3-28.
3 Continue to hold the guide rails outward as you pull the SAS controller
daughter card upward from the rails.
If you need to replace the SAS daughter card battery, see "Replacing the SAS
RAID Controller Daughter Card Battery" on page 126.
Figure 3-28.
Installing and Removing the SAS Controller Daughter Card
1 SAS connector 0 (out
to 1x8 backplane
SAS_A connector)
2
SAS connector 1 (SAS RAID
only) (out to 1x8 backplane
SAS_B connector or 1x2
SAS_B_IN connector)
3
SAS controller
daughter card
4 RAID battery cable
(SAS RAID only)
5
daughter card slot socket
6
slide rails (2)
1
3
5
2
4
6
book.book Page 128 Monday, September 14, 2009 1:53 PM