Dell PowerVault DP600 - Manual (Page 80)

80
Installing System Components
Figure 3-10. Installing and Removing a Power Supply
Installing a Power Supply
1 If you are adding a second power supply, remove the power supply blank.
See "Removing the Power Supply Blank" on page 81.
2 Holding the handle in the open position, slide the new power supply
into the chassis until the release lever contacts the system chassis. See
Figure 3-10.
NOTICE:
On a rack system, you may need to temporarily unlatch and lift the cable
management arm. For information about the cable management arm, see the
system’s Rack Installation Guide.
1 power supply 2 handle 3 tab
4 power supply blank 5 screw 6 locking tab
4
1
5
2
6
3
book.book Page 80 Monday, September 14, 2009 1:53 PM