Dell PowerVault DP600 - Manual (Page 106)

106
Installing System Components
Replacing the Center Fan Bracket
1 Align the rails on each end of the fan bracket with the guide rails on the
chassis walls and lower the bracket down into the system until the latches
engage.
2 Reattach the cables to the SAS controller daughter card on the expansion
bay bracket.
3 Replace the fans into the fan bracket.
4 Close the system. See "Closing the System" on page 68.
5 Replace the front bezel, if removed.
6 Reconnect the system to the electrical outlet and turn on the system and
attached peripherals.
Removing the Back Fan Bracket
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on page 64.
3 Open the system. See "Opening the System" on page 67.
4 Remove the memory cooling shroud. See "Removing the Cooling
Shroud" on page 103.
5 Remove the fans from the back fan bracket. See "Removing and
Installing a Fan" on page 83.
6 To remove the back fan bracket, push down on the blue latch along the
rear chassis wall and slide the bracket upwards. See Figure 3-20.
Replacing the Back Fan Bracket
1 Slide the left and right edges of the bracket into the two corresponding
channels on the inside of the system chassis back panel. See Figure 3-20.
book.book Page 106 Monday, September 14, 2009 1:53 PM