Dell PowerVault DP600 - Manual (Page 183)

Jumpers and Connectors
183
Figure 6-4. 1x2 SAS Backplane Connectors
Disabling a Forgotten Password
The password jumper on the system board enables the system password features
or disables them and clears any password(s) currently in use.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Remove the bezel, if attached. See "Removing the Bezel" on page 64.
3 Open the system. See "Opening the System" on page 67.
4 Note the cable connections on the SAS daughter card, and then
disconnect the cables from the storage daughter card and extend the
cables away from the center fan bracket.
1 power connector 2 SAS_B_IN connector 3 SAS_B_OUT connector
1
2
3
book.book Page 183 Monday, September 14, 2009 1:53 PM