Pilz PMCprotego D.72/000/0/0/2/208-480VAC - Manual (Page 175)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-67
6.8 Expansion cards
6 Wiring
6.8.6 Expansion card with DeviceNet interface
Expansion card with DeviceNet interface 6- ][Verdr_DeviceNet_protego_D
When installing and wiring please refer to the “DeviceNet Specification,
Volume I, II, Version 2.0”, published by ODVA. This contains information
on:
 Cable selection
 Cable routing
 Shielding
 Bus connectors
 Bus termination
 Runtimes
Correct wiring:
 Stub lines of 0 ... 6 m are permitted on each device.
 Branches within stub lines are permitted.
 Voltage to the devices can be supplied via the bus
Connection
Interface SERCOS
Connect the FO cable to the F-SMA
plug-in connector on the transmitter
and receiver.
Hand-tighten the union nut in a
clockwise direction.
Structure of the ring-shaped SER-
COS bus system with fibre-optic ca-
ble (schematic diagram)
Receive data:
F-SMA connector on X13
Send data:
F-SMA connector on X14
SERCOS
Controller
Servo Drive
SERCOS 1
Receive X13
Transmit X14
Servo Drive
SERCOS 2
Servo Drive
SERCOS 3
Receive X13
Transmit X14
Receive X13
Transmit X14
Receive
Transmit