Pause – Xtramus NuWIN-RM V1.4 User Manual

Page 106

Advertising
background image


106

E-mail: [email protected]

Website: www.Xtramus.com

XTRAMUS

®

9.3.3. ARP

ARP stands for Address Resolution Protocol, a protocol used for resolution of Layer 3 addresses into

Layer 2 addresses during internetwork transmissions.

ARP

Hardware Type

This field specifies the network protocol type. You can set the Hardware Type
as 0-Unknow or 1-Ethernet.

Protocol Type

The Protocol Type field allows you to set the Ethernet frame which is used to
indicate which protocol is encapsulated in the PayLoad of an Ethernet Frame.
For example, Protocol Type as 08:00 indicates IPv4 protocol.

Hardware Address

Length

This field allows you to set length (in octets) of a hardware (MAC) address.

Protocol Address

Length

This field allows you to set length (in octets) of a protocol (IP) address.

Operation

This field allows you to set the operations the sender will take. The operations
include 0-Unknown, 1-ARP Request, 2-ARP Reply, 3-RARP Request, and
4-RARP Reply.

Sender

Hardware/Protocol

Address

You can set the sender

’s (source) MAC/IP addresses here.

Target

Hardware/Protocol

Address

You can set the target

’s (destination) MAC/IP addresses here.

9.3.4. Pause

The PAUSE frame is a frame that halts the transmission of the sender for a specified period of time.

Pause

Destination Address This field displays the destination MAC address.

Source Address

This field displays the source MAC address.

Type

This field displays the protocol type of the Pause Frame (88:08).

Opcode

This field displays the Operation Code (opcode).

Pause

You can set the pause value here in this field.

Advertising