Xtramus NuWIN-RM V1.4 - Manual (Page 78)

78
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS ®
6.8. Ping Function
As a network utility, Ping is widely used for testing if one specific host is reachable through its IP address.
Also, Ping can be used to measure the time it takes to transmit packets from a local host to the
designated computer located on a network and back.
Accessing Ping Function

Click Ping Function on the Module Info/Configuration List

Press Ping Function button on the Quick Launch Buttons.
A Ping Function window will pop up, as shown in the picture down below.
To perform the ping command via specific
port, please check the check-boxes on the
Reserved Ports list. The port you ’ve selected
will be displayed on the main display screen
located on the right side of the Ping Function
window, as shown in the picture on the right
side.
Each port you
’ve chosen contains 24 sets of
different MAC Addresses, IPv4 addresses,
IPv6 addresses, and VLAN IDs.
There are two tab-menus available for you to
make layer 3 testing configurations, including
ARP&NDP Configuration, and Ping Function. Please see the sections down below for more details.