BECKHOFF EP9214-0023 - Manual (Page 16)

Mounting and cabling
Ethernet/EtherCAT Plug connector Cable Standard
Signal Descrip-
tion M8 M12 RJ45 1 ZB9010, ZB9020,
ZB9030, ZB9032,
ZK1090-6292,
ZK1090-3xxx-xxxx ZB9031 and old
versions
of ZB9030, ZB9032,
ZK1090-3xxx-xxxx TIA-568B
Tx + Transmit
Data+ Pin 1 Pin 1 Pin 1 yellow 2 orange/white 3 white/
orange
Tx - Transmit
Data- Pin 4 Pin 3 Pin 2 orange 2 orange 3 orange
Rx + Receive
Data+ Pin 2 Pin 2 Pin 3 white 2 blue/white 3 white/green
Rx - Receive
Data- Pin 3 Pin 4 Pin 6 blue 2 blue 3 green
Shield Shield Housing Shroud Screen Screen Screen
1 ) colored markings according to EN 61918 in the four-pin RJ45 connector ZS1090-0003
2 ) wire colors according to EN 61918
3 ) wire colors
Note
Assimilation of color coding for cable ZB9030, ZB9032 and ZK1090-3xxxx-
xxxx (with M8 connectors)
For unification the prevalent cables ZB9030, ZB9032 and ZK1090-3xxx-xxxx this means
the pre assembled cables with M8 connectors were changed to the colors of EN61918 (yel-
low, orange, white, blue).So different color coding exists. But the electrical properties are
absolutely identical.
EtherCAT connectors
The following connectors can be supplied for use in Beckhoff EtherCAT systems.
Designation Plug connector Comment
ZS1090-0003 RJ45 four-pin, IP20, for field assembly
ZS1090-0004 M12 four-pin, IP67, for field assembly
ZS1090-0005 RJ45 eight-pin, IP20, for field assembly,
suitable for Gigabit Ethernet
ZS1090-0006 M8 four-pin, IP67, for field assembly
ZS1090-0007 M8 socket four-pin, IP67, for field assembly, for ZB903x cable
ZS1090-1006 M8 plug four-pin, IP67, for field assembly up to OD = 6.5 mm
ZS1090-1007 M8 socket four-pin, IP67, for field assembly up to OD = 6.5 mm
3.2.2 EtherCAT - Fieldbus LEDs
Fig. 14: EtherCAT-LEDs
EP9214-0023 and EP9224-0023 16 Version 2.0.0