Compuprint 4247-Z03 - Manual (Page 105)

Override Host Parameters
Note: Host Override is not available for IPDS.
Paper Source
This parameter allows the printer to accept or ignore (override) the Paper Source
selection commands that are sent by the host data stream. You can set Paper
Source to:
Disabled
(Default) The printer accepts and processes commands received from the host data
stream for paper source selection.
Enabled The printer ignores commands received from the host data stream that
specify paper source selection. The printer will use the paper source selected
at the operator panel. Commands sent from the host cannot override the
paper source selected at the operator panel.
To change or check the Paper Source:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Override Host
5. Press ENTER, and the printer displays
Override Host
Paper Source
6. Press ENTER to display the current value.
7. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Paper Source is displayed.
8. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
9. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Characters Per Inch (CPI)
This parameter allows the printer to accept or ignore (override) the Characters Per
Inch commands that are sent by the host data stream. You can set Characters Per
Inch to:
Disabled
(Default) The printer accepts and processes commands received from the host data
stream, for Characters Per Inch selection.
Enabled The printer ignores commands received from the host data stream, for
Characters Per Inch. The printer will use the Characters Per Inch value set in
the printer configuration.
Chapter 7. ASCII Configuration 89