Maintenance, Removing the ribbon cartridge, Cleaning the printer – Compuprint 4247-Z03 User Manual
Page 168: Freeing the shifter holder, Maintenance removing the ribbon cartridge
Maintenance
Removing the ribbon cartridge
Attention:
Damage to the printer can occur if you do not use an approved ribbon
(part number 57P1743) especially designed for the 4247 Model Z03 printer.
CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes
for parts in this area to cool before handling.
To remove an existing ribbon cartridge, follow these steps:
1.
Open the printer top cover.
2.
Slide the printhead to the center of the printer.
3.
Slide the ribbon guide out of the printhead.
4.
Free the shifter holder by pushing the tab towards the rear and pulling the
shifter holder up.
5.
Now you are ready to insert the new ribbon cartridge (see “Installing the
ribbon cartridge” on page 12).
Cleaning the Printer
CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes
for parts in this area to cool before handling.
Figure 42. Freeing the shifter holder
152
User's Guide